Valve fittings

wba 1879 · Post by **wba 1879** » 21 Feb 2021, 09:52

I have a bravo BP12 pump. I bought the pump and inflatable from the same store and they fitted the push push fitting to the pump rather the a Halkey Robert's one. The pump came with a HR fitting but haven't tried it on mine so not sure if it fits. The push push one does pop off so has to be held. Just wondered why the would use the push push rather than the HR fitting.

harrison · Post by **harrison** » 21 Feb 2021, 15:01

No idea.

If you have the correct Halkey Robert’s bayonet fitting....use it.

Many tend to be generic and may find you need to change washer thickness to get a good seal. Also some have an internal plunger (fixed or adjustable) which opens the inner inflation valve which also need adjusting.

wba 1879 · Post by **wba 1879** » 21 Feb 2021, 16:59

Thanks again for your reply, I have seen one for sale for my sib so will get one.

wba 1879 · Post by **wba 1879** » 25 Feb 2021, 10:45

The one that came with the bravo pump fitted with the washer removed so swapped over now, cheers

wba 1879 · Post by **wba 1879** » 27 Feb 2021, 08:18

Should have read without the washer removed.

F-Ribs And Sibs - Inflatable Boat Community

Valve fittings

Valve fittings

Re: Valve fittings

Re: Valve fittings

Re: Valve fittings

Re: Valve fittings