I too, are trying to find a cover (other than the Honda one) to fit my T40.
Triumph, would you recommend size 2 or next size up
Regards
GT
Honwave boat cover
-
warder54
- Super Poster
- Posts: 645
- Joined: 12 Aug 2016, 08:32
- Boat Make: F-Rib 360 + Smartwave 480
- Outboard: Yam 60 efi
Toh 5 4 st
Toh 20 efi - MMSI Number: 10
- Location: Montrose -Scotland
- Has thanked: 23 times
- Been thanked: 148 times
Re: Honwave boat cover
I bought the one from Ducks back (?Ducksback) quite cheap - cant remember how much I paid. Into it's 3rd year and still going strong.
Why am I here - I should be in my boat fishing!!
Mike Elliott
Mike Elliott
-
warder54
- Super Poster
- Posts: 645
- Joined: 12 Aug 2016, 08:32
- Boat Make: F-Rib 360 + Smartwave 480
- Outboard: Yam 60 efi
Toh 5 4 st
Toh 20 efi - MMSI Number: 10
- Location: Montrose -Scotland
- Has thanked: 23 times
- Been thanked: 148 times
Re: Honwave boat cover
Pic didn't attach, try again
Why am I here - I should be in my boat fishing!!
Mike Elliott
Mike Elliott
-
warder54
- Super Poster
- Posts: 645
- Joined: 12 Aug 2016, 08:32
- Boat Make: F-Rib 360 + Smartwave 480
- Outboard: Yam 60 efi
Toh 5 4 st
Toh 20 efi - MMSI Number: 10
- Location: Montrose -Scotland
- Has thanked: 23 times
- Been thanked: 148 times
Re: Honwave boat cover
That I can't remember, sorry. But the web site had instructions on where to measure and I ordered the reccomended size ( I may have gone up one to allow for the canopy and outboard!) If you measure the whole set up it will be fine.
Why am I here - I should be in my boat fishing!!
Mike Elliott
Mike Elliott
-
Froglet
- Advanced Member
- Posts: 269
- Joined: 15 Apr 2018, 13:32
- Boat Make: Honwave T38 ie1
- Outboard: Mariner 25hp 2s, Yamaha 6hp 4s
- MMSI Number: 235918142
- Location: South Bucks
- Has thanked: 42 times
- Been thanked: 91 times
Re: Honwave boat cover
I bought the size 2 for my T38 and while it works for me you can see the ends of the tubes peek out a little.
I made a simple frame out of PVC electrical duct tube to stop water pooling and that has contributed to the fit being a little close.
The T40 is 20cm longer and 20cm wider than the T38, so you can see that you'll need a bigger size than the 2. Whether you need a 3 or a 4 I can't say, but hope this helps a bit.
- Ducksback size 2 on a T38
I made a simple frame out of PVC electrical duct tube to stop water pooling and that has contributed to the fit being a little close.
The T40 is 20cm longer and 20cm wider than the T38, so you can see that you'll need a bigger size than the 2. Whether you need a 3 or a 4 I can't say, but hope this helps a bit.
