Very similar concept to the JDS Outdoors video but probably a bit simpler. All I wanted really was a power outlet I could use for the Bravo/Garmin and a USB outlet for "stuff".
Had 2 x 7.5Ah batteries already so wanted to use both rather than carry one in the Bravo bag and a seperate one for the Garmin. That way I only have one "Box" to carry.
Based on the "ammo case" approach this is where I have got to so far.
Case with main power switch and volt/amp meter on top so I can check battery and current draw
Just an example of it all hooked up running my Garmin and charging a torch
Inside it looks like this currently,
They are then run through an inline fuse to the master switch/voltmeter. From here the power runs to the fuse box and then onto the individual outputs.
The main feed from the battery also has a couple of Anderson connectors plumbed in which will be used for charging. I will adapt my battery charger terminals to Anderson as well so all I have to do is lift the lid, plug in the connectors and leave it to charge. this was a departure from most of the YouTube vid's that use posts mounted on the outside of the case for charging/power distribution. i didn't like that idea for something to be used in a marine environment
Few bits still to do, batteries will be held by velcro restraining straps, sockets/switches need a bead of silicon applied to them to ensure they seal, not sure if I will use the socket mounting plates that are on their at the moment or just mount direct. The plates when bolted or glued would stiffen up the socket mount but if bolted introduce more holes that can leak.....
And will then tidy the wiring up a bit more......
Still it all works which is nice
Cheers,
Paul.
