I previously transported my last air floor Sib on a bunked trailer with the outboard tilted and a support on the OB leg. Bow clipped to the winch and a ratchet strap from the trailers front, over the bow, over the transom, then clipped off to the trailer to stop the transom experiencing any undue loads.
I've purchased a new Indespension roller trailer for the F-Rib I've adjusted the rollers, draw bar and snub etc to fit the hull and I'm happy with the transom support position on the rear rollers The outboard will be carried on the boat in the fully down position as there's ample clearance between the skeg and the ground so most of the loading will be up and down I assume
The transom is part of the rear section of the fibreglass hull so was thinking should I ratchet strap it to support it, reducing the rearward loadings like this onto the towing eyes
Paul







