Anchoring a 3.5mtr sib
Posted: 08 Jul 2020, 17:17
So my quest today is to rid myself of the 2mtr of 8mm close link galvanized chain that's gone rusty.
I have a 2.5kg grapnel anchor and 100mtr of suitable rope for inshore fishing.
I'm looking at buying another 3mtr of 8mm galvanized chain (around 1kg/mtr) and use that linked directly to the anchor, its very shallow water where I will be fishing, 2-3mtr at lowest tide on average so I don't want anchor-rope-chain-rope if I can help it or I will be letting a lot of rope out at low water to set the anchor in the mostly sand & clay here.
Ive not had a sib before, but have used grp dinghy's. The idea I gather with sibs is not to have rope rubbing on the tubes, do I intended to have a 2-3mtr painter to the D ring at the pointy end and use something like a snap hook both ends so I can attach the anchor rope with a tied loop at whatever I think is long enough.
The rest of the anchor rope stays in the bucket on board along with the float I usually leave attached to the end.
In theory I pull on the anchor rope from the bucket to bring the painter back to a point where I can retrieve the rest of the rope/chain and anchor.
Is that setup suitable do we think?
I have a 2.5kg grapnel anchor and 100mtr of suitable rope for inshore fishing.
I'm looking at buying another 3mtr of 8mm galvanized chain (around 1kg/mtr) and use that linked directly to the anchor, its very shallow water where I will be fishing, 2-3mtr at lowest tide on average so I don't want anchor-rope-chain-rope if I can help it or I will be letting a lot of rope out at low water to set the anchor in the mostly sand & clay here.
Ive not had a sib before, but have used grp dinghy's. The idea I gather with sibs is not to have rope rubbing on the tubes, do I intended to have a 2-3mtr painter to the D ring at the pointy end and use something like a snap hook both ends so I can attach the anchor rope with a tied loop at whatever I think is long enough.
The rest of the anchor rope stays in the bucket on board along with the float I usually leave attached to the end.
In theory I pull on the anchor rope from the bucket to bring the painter back to a point where I can retrieve the rest of the rope/chain and anchor.
Is that setup suitable do we think?