Anchor mount

[chris moody]

Best place to tie off the anchor warp to is the end of the painter, then no chance of any rubbing or chafing of tubes

[Mitch]

Spiffy, this is what i’ll Be using,
The fair lead is glued over the top of the tube for the anchor rope to slide in

The railblaza cleat port which is placed below the fair lead is used to tie off the anchor.

[Shaun]

Do you have links where to buy these please.

[Mitch]

http://www.henshaw.co.uk/images/products/large/179b.jpg
https://www.railblaza.com/assets/Produc ... w2MDBd.jpg

[Shaun]

http://www.henshaw.co.uk/images/products/large/179b.jpg
https://www.railblaza.com/assets/Produc ... w2MDBd.jpg

Thanks

Getting some the weekend.

[Mitch]

Spiffy, have phoned Henshaws up to get the faileader but they want £50 min order so will look somewhere else, if I cant find another then maybe i'll buy a couple to make up the order then i'll have a spare to pass onto someone else.

[Shaun]

Spiffy, have phoned Henshaws up to get the faileader but they want £50 min order so will look somewhere else, if I cant find another then maybe i'll buy a couple to make up the order then i'll have a spare to pass onto someone else.

Thanks, but looking at the front of the f-rib430 adding that would be a problem. They decided to put a wacking big FRIB logo patch on the front. So im going with the Railblaze and designing a bracked to 3d print that will allow the rope to be supported and not tough the tube. Not sure if ill make it static or allow it to swivel yet. Ill think about it once i have the cleatport mounted.