Hi all
Anyone have their 350 inflated?
I am looking for the measurement from the bottom of the tubes to the floor of the boat as in picture attached.
This is to gauge if the tubes would hit the wheel arches, and therefore require longer support tubes.
Thanks
Dimensions inflated help
-
Notebook64
- Active Member
- Posts: 131
- Joined: 26 Dec 2020, 14:41
- MMSI Number: 10
- Location: Cardiff
- Has thanked: 17 times
- Been thanked: 3 times
-
harrison
- Mega Poster, I Really Need To Get Out More !
- Posts: 1846
- Joined: 18 Mar 2015, 17:14
- Boat Make: XS500/Merc340/Elling/Bic
- Outboard: Mariner60,20,3.5,Tohatsu9.8,Hon2.3,ThrustMe Kicker
- Location: Midlands & Up North
- Has thanked: 284 times
- Been thanked: 746 times
Re: Dimensions inflated help
Just under 150mm
Found this pic we already had.
Found this pic we already had.
- These users thanked the author harrison for the post:
- Notebook64 (18 Aug 2022, 14:38)
harrison
'The Beatings Will Continue Until Morale Improves'
'The Beatings Will Continue Until Morale Improves'
-
Notebook64
- Active Member
- Posts: 131
- Joined: 26 Dec 2020, 14:41
- MMSI Number: 10
- Location: Cardiff
- Has thanked: 17 times
- Been thanked: 3 times
-
harrison
- Mega Poster, I Really Need To Get Out More !
- Posts: 1846
- Joined: 18 Mar 2015, 17:14
- Boat Make: XS500/Merc340/Elling/Bic
- Outboard: Mariner60,20,3.5,Tohatsu9.8,Hon2.3,ThrustMe Kicker
- Location: Midlands & Up North
- Has thanked: 284 times
- Been thanked: 746 times
Re: Dimensions inflated help
Correct.
- These users thanked the author harrison for the post:
- Notebook64 (18 Aug 2022, 16:46)
harrison
'The Beatings Will Continue Until Morale Improves'
'The Beatings Will Continue Until Morale Improves'
