Borika Mounts for the Elling 350KB
-
KGslo
- I'm New
- Posts: 21
- Joined: 28 Jul 2020, 09:25
- Boat Make: Elling KB350
- Outboard: Yamaha Enduro 8 hp
- Location: Odense
- Has thanked: 9 times
- Been thanked: 1 time
Re: Borika Mounts for the Elling 350KB
Hi Sibfisher and Gray. I am about to mount a transducer on my KB350. Are you still using your telescopic and non-telescopic arms today and would you done anything differently if you were to install the transducer today?
-
Gray
- Advanced Member
- Posts: 192
- Joined: 25 Oct 2019, 11:26
- Boat Make: Elling KB 350
- Outboard: Tohatsu 9.8
- MMSI Number: 10
- Location: Hull
- Has thanked: 28 times
- Been thanked: 60 times
- Contact:
Re: Borika Mounts for the Elling 350KB
Mine is still fine. If I am doing any major distance/speed I will lift it. It also works great with my side imaging transducer.
I bought the telescopic version, but I have just riveted it in place with no extension being used. The standard non-telescopic version would probably be more sturdy.
I bought the telescopic version, but I have just riveted it in place with no extension being used. The standard non-telescopic version would probably be more sturdy.
-
KGslo
- I'm New
- Posts: 21
- Joined: 28 Jul 2020, 09:25
- Boat Make: Elling KB350
- Outboard: Yamaha Enduro 8 hp
- Location: Odense
- Has thanked: 9 times
- Been thanked: 1 time
Re: Borika Mounts for the Elling 350KB
Good to hear, Gray. I just ordered the non-telescopic version. I will probably mount the fitting on a piece of wood at first and use a g-clamped to fix it on the transom so I can find the correct position before drilling in the transom.
