Anchor mount

Sib,Frib & Rib modifications.
Share your mods with the forum
chris moody
Supporting Member
Posts: 1455
Joined: 24 Mar 2015, 12:19
Boat Make: Honwave T32IE
Outboard: Tohatsu 9.8
MMSI Number: 235900806
Location: Davetry & Porchester
Has thanked: 42 times
Been thanked: 163 times
Contact:

Re: Anchor mount

Post by chris moody » 13 Jun 2018, 16:06

Best place to tie off the anchor warp to is the end of the painter, then no chance of any rubbing or chafing of tubes
Chris Moody

Tiny Tigga - Honwave T32IE with launch wheels Honda 2hp 4 stroke air cooled & Tohatsu 9.8 2 stroke
Tigga 2 - Ribcraft 4.8 Honda BF50
http://twitter.com/aslmarine

Mitch
Supporting Member
Posts: 242
Joined: 16 May 2017, 16:31
Boat Make: Honwave T38-ie2
Outboard: Mercury 20HP Fourstroke
MMSI Number: 10
Location: Swindon
Has thanked: 66 times
Been thanked: 32 times

Re: Anchor mount

Post by Mitch » 13 Jun 2018, 16:27

Spiffy, this is what i’ll Be using,
The fair lead is glued over the top of the tube for the anchor rope to slide in
DC7DAA04-D1C8-42B3-80E0-8B27C5F31775.jpeg
The railblaza cleat port which is placed below the fair lead is used to tie off the anchor.
8E366CCF-9E9A-4C10-BB32-0F345311BB00.jpeg

Spiffy
Newish Member, But I Like It Here
Posts: 24
Joined: 05 Mar 2018, 15:15
MMSI Number: 10
Location: Epsom
Has thanked: 2 times
Been thanked: 2 times

Re: Anchor mount

Post by Spiffy » 14 Jun 2018, 10:37

Do you have links where to buy these please.

Mitch
Supporting Member
Posts: 242
Joined: 16 May 2017, 16:31
Boat Make: Honwave T38-ie2
Outboard: Mercury 20HP Fourstroke
MMSI Number: 10
Location: Swindon
Has thanked: 66 times
Been thanked: 32 times

Re: Anchor mount

Post by Mitch » 14 Jun 2018, 21:11


Post Reply

Return to “DIY & Modifications”